CST PRECEDEO - DEMON CAMBER WHEELS

⭐CST PRECEDEO DOALL - DEMON CAMBER WHEELS 

⭐Very famous and used on Nissan S13, Silvia, Miata, CIvic etc... It was one of the most used wheel for the Kanagawa look, very popular in the 90's on S13 Silvias.

⭐The look was made famous by Pro Shop Wave. (B.Wave)

⭐Available sizes:

• 15inches 7J, Offset+4 or +19 (depending on the Disk chosen)
• 15inches 7.5J, Offset-5
• 15inches 8J, Offset+0
• 15inches 8.5J, Offset-5
• 15inches 9J, Offset+0
• 15inches 9.5J, Offset-30
• 15inches 10J, Offset-31

They are available in A Disk or O Disk. A Disk (Standard) has a thicker center face for better brake clearance but less lip, while O Disk (Low/Deep Dish) has a thinner face, allowing for a much deeper outer lip but offers minimal brake caliper clearance, often used on rear wheels for maximum visual impact.

⭐The wheels can be ordered with PCD 4x114 or 4x100. Perfect for a Mazda MX5 (Miata in the USA)

⭐This is the reprint model from the original maker CST using the same mold as before, so they are NEW with minor aesthetic differences and improved safety and strength.

• Air valve NOT INCLUDED BUT AVAILABLE SEPARATELY. Caps NOT AVAILABLE.

All CST wheels are tailor-made to your requirements. As such, wheels are made to order in Japan. Manufacturing and shipping can take max 6 months from the order for that reason, but that's depends on the options chosen so with common sizes selected they will be delivered way faster than that if in stock.

IMPORTANT: All CST wheels are tailor-made just for you, any orders for CST wheels are non-returnable and non-refundable unless there is a manufacturing fault.

IMPORTANT: These wheels will be shipped from Japan directly to you.

DISCLAIMER: NOT intended for street use! Only for use on vehicles that will never be used, registered, or licenced for use on road or off road.

• IMPORTANT! This wheel is NOT AVAILABLE for ITALY's market due to wheel regulations.